Configure Simple Network Management Protocol (Snmp); Configure Network Time Protocol (Ntp) - Avaya 4550T-PWR+ Fundamentals

ping [<ipv6address> | <Hostname or
A.B.C.D>] [source <WORD>]
show ip

Configure Simple Network Management Protocol (SNMP)

Perform the commands in the following table to configure SNMP.
snmp-server enable
snmp-server authentication-
trap enable
snmp-server community ro
snmp-server community rw
snmp-server contact
want"
snmp-server location
Closet #>"
snmp-server name
address>"
snmp-server host
<community>
show sys-info
show snmp host

Configure Network Time Protocol (NTP)

Perform the commands in the following table to configure NTP and verify the configuration.
Fundamentals
Command
Command
"whatever you
"<Building &
"<switch IP
<host IP>
Configure Simple Network Management Protocol (SNMP)
Purpose
Verify connectivity between a source IPv4
address and another interface.
Verify configuration.
Purpose
Enable SNMP (the default setting is
disabled).
Enable authentication traps.
Set the read-only community name
(requirement: enter community string
twice).
Set the read-write community name
(requirement: enter community string
twice).
Set contact information.
Set building name and closet information.
Maintain coherent Syslog messages.
Set IP address of Jscan trap receiver.
Verify configuration.
Verify configuration.
December 2011 75