Configure A Port - Avaya 4550T-PWR+ Fundamentals

show ip igmp group-ext member-
subnet<A.B.C.D/<0–32>>
show ip igmp group-ext source
<A.B.C.D>
show ip igmp interface
show ip igmp interface vlan
<1–4094>
show ip igmp router-alert
show ip igmp router-alert vlan
<1–4094>
show ip igmp snooping
vlan igmp <VID> snooping
enable
vlan igmp <VID> proxy enable
show vlan igmp <VID>

Configure a port

Perform the commands in the following table to configure a port.
interface fastEthernet
port list>
auto-negotiation-
advertisements 10-full 10-
half 100-full 100-half pause-
frame
default auto-negotiation-
advertisement
poe poe-shutdown
Fundamentals
Command
Command
<end-user
Purpose
Display the IGMP group extended details for
the selected member subnet
Display the IGMP group extended details for
the selected source address.
Display IGMP interface information.
Display IGMP interface information for the
selected VLAN.
Display router-alert settings.
Display router-alert settings for the selected
VLAN.
Display IGMP snooping information
Enable IGMP snooping on each appropriate
VLAN.
Enable IGMP proxy on each appropriate
VLAN.
Show IGMP information for each appropriate
VLAN.
Purpose
Enter configuration mode at the interface
level where you can configure multiple ports,
excluding uplink ports, simultaneously.
Set 10/100 ports to advertise only 10Mb/s
half duplex and 100Mb/s half duplex.
To advertise gigabit for gigabit ports because
Custom Autonegotiation Advertisements
(CANA) is not appropriate for gigabit ports.
Because Power Over Ethernet (PoE) is on by
default, use this command to disable PoE on
non-PoE ports.
Configure a port
December 2011 79