Configure Internet Group Management Protocol (Igmp) - Avaya 4550T-PWR+ Fundamentals

Vlan configcontrol automatic
vlan ports <uplink port>
tagging tagall
vlan ports <uplink port>
filter-untagged-frame enable
vlan ports ALL filter-
unregistered-frame disable
vlan create <VID> type port
vlan name <VID> <name>
vlan menbers add <VID> <port
listing>
vlan mgmt <VID>
vlan members remove 1 ALL
vlan ports <uplink port> pvid
<VID>
show vlan
show vlan interface info

Configure Internet Group Management Protocol (IGMP)

Perform the commands in the following table to configure IGMP.
[no][default]ip igmp
ip igmp flush vlan <1–
4094>[grp-member][mrouter]
[default] ip igmp last-
member-query-interval <0–255>
Fundamentals
Command
Command
Configure Internet Group Management Protocol (IGMP)
Purpose
Automatically delete old VLANs and update
PVID when a VLAN is added to an untagged
port (setting appears at the bottom of the
VLAN configuration information).
Enable tagging on the uplink.
Discard untagged frames.
Break STP for VoIP.
Create the port based VLAN and assign the
802.1q identifier.
Name the VLAN according to conventions.
Add ports to appropriate VLANs.
Set the management VLAN.
Remove all ports from VLAN 1.
Set the PVID on the uplink.
Verify VLAN configuration.
Verify configuration of PVID and port type.
Purpose
Configure/restore/clear/delete IGMP
settings per VLAN.
Flush the group member or IGMP Mrouter on
selected VLAN interface
Configure/restore default last member query
interval per VLAN.
December 2011 77