Back-Panel Components - Nortel BayStack 350 Series Manual

Using the BayStack 350 Series 10/100 Autosense Switch

Back-Panel Components

This section describes the back-panel components of the BayStack 350 switches
(Figure
• The console/service port for the Model 350F-HD and Model 350T-HD is
located on the front panel (see
• The console/service port for the Model 350F and Model 350T is located on
the back panel.
For a description of each numbered component, see
BayStack 350F-HD
M/N AL2012A01
BayStack 350T
M/N AL2012A01
Figure 1-3. Back-panel components
Table 1-2. Back-panel components
Item Icon/Label
1
2 RS232
1
3
The console/service port for the Model 350F-HD, labeled Comm Port, is located on the front panel.
1
The AC power receptacle is mounted with the ground pin below on some early units. Later units are configured as
2
shown above. The receptacle is keyed and the AC power cord cannot be installed incorrectly.
1-4
1-3).
1
BayStack Model 350F-HD/350T-HD back panel
1
BayStack Model 350F/350T back panel
Description
Manufacturing label: Lists the model number, serial number, MAC address, and
voltage rating.
Console/service port DB-9 (RS-232-D) serial port connector: Allows the attachment
of a console terminal device for accessing the console interface (CI) screens.
AC power receptacle : Accepts the AC power cord (supplied).
2
"Front-Panel Components" on
Table
3
3
2
RS232
7830EB
page 1-2).
1-2.
893-00992-E