F12; Hard Disk Format - Konica Minolta bizhub 250 Service Manual

Field Service Ver. 1.0 Aug. 2005
11.8.4 F7-2
Functions • To automatically adjust the Original Size Detecting Sensor. (only for a FAX)
• When the Original Size Detecting Sensor is replaced
Use
• When an optional sensor is mounted
Setting/ For details on adjustment, see the Service Manual for Option FK-503.
Procedure
11.8.5 F8
Functions • To automatically adjust the ATDC sensor.
Use • When developer is replaced
1. From the Tech. Rep. Mode screen, touch [Function] → [F8] in that order.
2. Press the Start key to perform the ATDC sensor gain adjustment.
Setting/
• After the adjustment is finished, the operation stops automatically.
Procedure
• The adjusted setting overwrites the current setting for ATDC Sensor Gain in Printer of
Tech. Rep. Mode.
11.8.6

F12

Functions
• To print on paper with the engine unit and check the printing and paper feeding in the
paper take-up/transport sections.
Use
1. From the Tech. Rep. Mode screen, touch [Function] → [F12] in that order.
Setting/ 2. Select the paper source, and then press the Start key.
Procedure Touch [Duplex] to feed out the paper along the paper path for 2-sided copying.
3. The sequence is halted when the Stop key is pressed or there is no paper.
11.8.7

Hard Disk Format

Functions • To format the hard disk.
• When a hard disk drive is installed.
Use
• When the hard disk is initialized.
1. From the Tech. Rep. Mode screen, touch [Function] → [Hard Disk Format] in that
order.
2. Press the Start key to start the HDD formatting sequence.
Setting/
NOTE
Procedure
• NEVER turn OFF the power while the formatting sequence is in progress.
3. Turn OFF the Main Power Switch, wait for 10 sec. or more, and turn ON the Main
Power Switch again.
EDNord - Istedgade 37A - 9000 Aalborg - telefon 96333500
11. Tech. Rep. Mode
163