F12 - Konica Minolta bizhub 200 Service Manual

Field Service Ver. 2.0 Apr. 2006
10.8.2 F2
• This test is for factory adjustment only and should NOT be used.
10.8.3 F7-1
Functions • To automatically adjust the Original Size Detecting Sensor.
• When the Original Size Detecting Sensor is replaced
Use
• When an optional sensor is mounted
1. From the Tech. Rep. Mode screen, touch [Function] → [F7-1] in that order.
Setting/
Procedure P.109
10.8.4 F7-2
Functions • To automatically adjust the Original Size Detecting Sensor. (only for a FAX)
• When the Original Size Detecting Sensor is replaced
Use
• When an optional sensor is mounted
Setting/ See P.34 of the FK-503 service manual.
Procedure
10.8.5 F8
Functions • To automatically adjust the ATDC sensor.
Use • When developer is replaced
1. From the Tech. Rep. Mode screen, touch [Function] → [F8] in that order.
2. Press the Start key to perform the ATDC sensor gain adjustment.
Setting/
• After the adjustment is finished, the operation stops automatically.
Procedure
• The adjusted setting overwrites the current setting for ATDC Sensor Gain in Printer of
Tech. Rep. Mode.
10.8.6

F12

Functions
• To print on paper with the engine unit and check the printing and paper feeding in the
paper take-up/transport sections.
Use
1. From the Tech. Rep. Mode screen, touch [Function] → [F12] in that order.
Setting/ 2. Select the paper source, and then press the Start key.
Procedure Touch [Duplex] to feed out the paper along the paper path for 2-sided copying.
3. The sequence is halted when the Stop key is pressed or there is no paper.
10. Tech. Rep. Mode
165