Figure 13-3 Mirroring: Summary Table - ZyXEL Communications dimension ES-4024 User Manual

Dimension ES-4024 Ethernet Switch
LABEL
IP You can only specify the Port Number field when you specify an IP address and address prefix.
Address/Address
Enter a source IP address in dotted decimal notation.
Prefix
Specify the address prefix by entering the number of ones in the octet.
Port Number
You must first set the IP Address/Address Prefix fields and select either UDP or
Specify the port(s) to which the rule should be applied.
Select Any to apply to all ports or select the second option and enter a port number.
Destination The next three fields pertain to the destination IP address and destination port.
Ignore Click this check box to ignore any traffic to all destination ports.
IP Enter a destination IP address in dotted decimal notation.
Address/Address
Specify the subnet mask by entering the number of ones in the octet.
Prefix
Port Number
You must first set the IP Address/Address Prefix fields and select either UDP or
Specify the port(s) to which the rule should be applied.
Select Any to apply to all ports or select the second option and enter a port number.
Add Click Add to inset the entry to the summary table below.
Cancel Click Cancel to reset the fields.
Clear Click Clear to start configuring the screen again.
13.2.4 Editing and Viewing a Mirroring Rule
To view a summary of the rule configuration, scroll down to the summary table at the bottom of the Mirroring
screen.
To change the settings of a rule, click a number in the Index field.
The following table describes the related labels in this screen.
13-4
Table 13-2 Mirroring: Configuring a Mirroring Rule

Figure 13-3 Mirroring: Summary Table

DESCRIPTION
TCP in the Protocol field.
TCP in the Protocol field.
Mirroring