ZyXEL Communications dimension ES-4024 User Manual page 146

Dimension ES-4024 Ethernet Switch
socket
snmp
22-6
Table 22-1 CLI Command Summary: SYS
COMMAND
phywrite <portID> <phyAddr>
<data>
dbm mac count [port]
dbm mac list [port]
dbm mac flush [port]
dbm mac search <MAC> <VID>
dbm ip list [port]
log level [0-4]
log switch on/off
log list
log module <module_id> <on/off
log switch < on|off >
memdum <start_addr> <length>
wreg <addr> <value>
rreg <addr>
show_int_count
clear_int_count
getCommunity <index>
[<community>]
setCommunity <index>
[<community>]
trustedHost <index>[<hostt>]
DESCRIPTION
Writes PHY register
Displays number of MAC
addresses in L2 DBM
Displays entries in L2 DBM
Flushes learned MAC addresses in
the forwarding table.
Searches the MAC/VID learnt on
which port.
Displays entries in L3 DBM
Sets the log level. Logs displayed
consist of critical, error, warning,
debug and informational messages
in order of severity. Log level "4"
displays all messages; log level "0"
just displays critical messages.
Outputs messages to the console
or telnet screen.
Lists all IXE log modules.
Enables/disables log on specific
IXE module
Logs all modules to tracelog.
(Current display to console
directly)
Displays the switch chip's memory
map for the block specified.
Writes to a register.
Reads from a register.
Displays the interrupt counter.
Resets the interrupt counter.
Displays the system socket's ID #,
type, control block address (PCB),
IP address and port number of
peer device connected to the
socket (Remote Socket) and task
control block (Owner).
Sets or displays the SNMP
GetRequest community.
Sets or displays the SNMP
SetRequest community.
Sets or displays the SNMP trusted
host.
Introduction to CLI