ZyXEL Communications dimension ES-4024 User Manual page 145

monitor
ixe2424
Introduction to CLI
Table 22-1 CLI Command Summary: SYS
COMMAND
switch [on|off]
cnt [value]
status
show
vlimit <idx> <high> <low>
tlimit <idx> <limit>
flimit <bank> <idx> [<limit>]
fanmask <bank> [<mask>]
vclear
tclear
fclear
clear
enable [<on/off>]
test
lbt intlbt <port|All> [count]
lbt extlbt <port> [count]
pktcnt <port 1-28>
pktcntclear <port 1-28>
port <portID> <enable | disable>
<Speed> <FlowCtrl>
phyread <portID> [<phyAddr>]
Dimension ES-4024 Ethernet Switch
DESCRIPTION
Turns the watchdog firmware
protection feature on or off.
Sets (0-34463) or displays the
current watchdog count (in 1.6 sec
units).
Displays the status of the hardware
monitor.
Displays the hardware monitor's
statistics.
Sets the maximum (<high>) or
minimum (<low>) voltage at the
specified point (<idx>).
Sets the maximum (<limit>)
temperature at the specified point
(<idx>).
Sets the maximum (<limit>) fan
revs per minute (RPM) at the
specified fan (<idx>) in the
specified bank (<bank>). A "bank"
delineates a set of fans.
Sets the fan detection mask in the
specified bank (<bank>). Use the
mask to disable monitoring of a
fan.
Clears the voltage statistics.
Clears the temperature statistics.
Clears the fan statistics.
Clears the hardware monitor
statistics.
Enables or disables the hardware
monitor.
Tests the hardware monitor chip.
ixe2424 refers to the switch chip.
Performs an internal loop back test
on a specified port or all ports.
Performs an external loop back
test on a specified port or all ports.
Display port statistic counter
Reset port statistic counter
Port setup
Reads PHY register
22-5