ZyXEL Communications dimension ES-4024 User Manual page 153

del
disable
display
set
trunk
del
disable
display
listView
set
ingress
set
get
viewAll
learn
enable
disable
display
isolate
disable
port
enable
mc
set
Introduction to CLI
Table 22-2 Command Summary: SYS SW
COMMAND
<Class Idx>
<src port><src mac><src vid><dest
port><dest mac><dest vid><max bw>
<id>
<group><# ports>
<port> <enable | disable>
<port>
[port]
[port]
[port]
<port> <Port-List (in Hex)>
<addr> <port>...
Dimension ES-4024 Ethernet Switch
DESCRIPTION
Delete a bandwidth control class.
Clears current run-time bandwidth
control rules.
Displays current run-time
bandwidth control rules.
Creates a bandwidth control rule
using source/destination port,
MAC address and VLAN group
information. "*" means "any".
The following commands relate to
trunking. Trunking is the grouping
of physical ports into one logical
higher-capacity link.
Delete a trunk group.
Clears current run-time trunk
settings.
Displays current run-time trunk
settings.
Displays member list of trunk.
Adds ports to a trunk group.
Sets ingress check on a port.
Gets ingress check state on a
port.
Gets ingress check state on all
ports.
Enables address learning on the
port.
Disables address learning on the
port.
Displays address learning status.
Disables port isolation.(All
connected)
Sets the port-list which can
connected to the specific port.
Enables port isolation.
Sets ports to a specific multicast
address
22-13