Figure 24-5 Garp Timer Command Example; Figure 24-6 Garp Status Command Example - ZyXEL Communications dimension ES-4024 User Manual

Dimension ES-4024 Ethernet Switch
This command sets the switch's GARP timer settings, including the join, leave and leave all timers.
Switches join VLANs by making a declaration. A declaration is made by issuing a Join message using GARP.
Declarations are withdrawn by issuing a Leave message. A Leave All message terminates all registrations. GARP
timers set declaration timeout values.
The following example sets the Join Timer to 300 milliseconds, the Leave Timer to 800 milliseconds and the Leave
All Timer to 11000 milliseconds.
ES-4024> sys sw garp timer 300 800 11000
24.4.3 GVRP STATUS
Syntax:
sys sw gvrp status
This command shows the switch's GVRP settings.
An example is shown next.
ES-4024> sys sw gvrp status
GVRP control block status:
gvrpEnable = 1
gvrpPortEnable:
OOOOOOOOOOOOOOOOOOOOOOOOXXXX
24.4.4 GVRP ENABLE
Syntax:
sys sw gvrp enable
This command turns on GVRP in order to propagate VLAN information beyond the switch.
24.4.5 GVRP DISABLE
Syntax:
sys sw gvrp disable
This command turns off GVRP so that the switch does not propagate VLAN information to other switches.
24-4

Figure 24-5 GARP TIMER Command Example

Figure 24-6 GARP STATUS Command Example

IEEE 802.1Q Tagged VLAN