9.1 Introduction to Filtering
Port filtering means sifting traffic from one or all ports to one or all ports based on the source and/or destination
IP and/or MAC addresses and VLAN group.
9.1.1
Note About Configuration
The following rules apply when configuring filtering.
•
The rule applies to traffic flowing in both directions if both a source and destination are specified.
•
The rule applies to traffic flowing in one direction if either a source or destination is specified.
•
No any-to-any rules are allowed. That is, you cannot select Ignore for both the source and destination ports.
•
No blank rules are allowed. If you do not select Ignore, you must set the related fields.
9.2 Configuring a Filtering Rule
Click Filtering to display the screen as shown next.
Filtering
This chapter discusses static IP and MAC address port filtering.
Dimension ES-4024 Ethernet Switch
Chapter 9
Filtering
9-1