Table 13-2 Mirroring: Configuring A Mirroring Rule - ZyXEL Communications dimension ES-4024 User Manual

The following table describes the related labels in this screen.
LABEL
Active Make sure to select this check box to activate your rule. You may temporarily deactivate a rule
without deleting it by deselecting this check box.
Name Type a descriptive name for this rule. This is for identification purpose only.
Rule Specify to which network layer (Layer 2 or Layer 3) this rule applies.
Layer 2
Set the related fields when you select Layer 2 in the Rule field.
Protocol Select the protocol traffic to which this rule applies.
Source The next three fields pertain to the source MAC address and source port.
Ignore Click this check box to ignore any traffic from all source ports.
MAC Address Select Any MAC/VID to apply the rule to all MAC address and VLAN group identification
numbers.
To specify a source, select the second choice and type a MAC address in valid MAC address
format (six hexadecimal character pairs) and then enter the VLAN group identification number.
Port Select the port to which the rule should be applied. You may choose one port only or all ports
(All Ports).
Destination The next three fields pertain to the destination MAC address and destination port.
Ignore Click this check box to ignore any traffic to all destination ports.
MAC Address Select Any MAC/VID to apply the rule to all MAC address and VLAN group identification
numbers.
To specify a destination, select the second choice and type a MAC address in valid MAC
address format (six hexadecimal character pairs) and then enter the VLAN group identification
number.
VID Type the VLAN group identification number.
Port Select the port to which the rule should be applied. You may choose one port only or all ports
(All Ports).
Layer 3
Set the related fields below when you select Layer 3 in the Rule field.
Protocol Select the protocol traffic to which this rule applies.
Source The next three fields pertain to the source IP address and source port.
Ignore Click this check box to ignore any traffic from all source ports.
Mirroring

Table 13-2 Mirroring: Configuring a Mirroring Rule

The VID for the source and destination must be the same.
Dimension ES-4024 Ethernet Switch
DESCRIPTION
13-3