Igmp; Figure 19-2 Rip; Table 19-3 Rip - ZyXEL Communications dimension ES-4024 User Manual

3. Outgoing - the ES-4024 will send out RIP packets but will not accept any RIP packets received.
4. None - the ES-4024 will not send any RIP packets and will ignore any RIP packets received.
The Version field controls the format and the broadcasting method of the RIP packets that ES-4024 sends (it
recognizes both formats when receiving). RIP-1 is universally supported; but RIP-2 carries more information.
RIP-1 is probably adequate for most networks, unless you have an unusual network topology.
Both RIP-2B and RIP-2M sends the routing data in RIP-2 format; the difference being that RIP-2B uses subnet
broadcasting while RIP-2M uses multicasting.
Click Routing Protocol and then RIP in the navigation panel to display the screen as shown. You cannot manually
configure a new entry. Each entry in the table is automatically created when you configure a new IP domain in the
IP Setup screen (refer to the section on IP routing domain setup).
The following table describes the labels in this screen.
LABEL
Active Select this check box to enable RIP on the switch.
Index This field displays the index number of the entry.
Network This field displays the IP domain configured on the switch.
Refer to the IP Setup section for more information on configuring IP domains.
Direction Select the RIP direction from the drop-down list box. Choices are Outgoing, Incoming,
Both and None.
Version Select the RIP version from the drop-down list box. Choices are RIP-1, RIP-2B and RIP-2M.
Apply Click Apply to save your changes back to the switch.
Cancel Click Cancel to begin configuring the fields again.

19.3 IGMP

IGMP (Internet Group Multicast Protocol) is a session-layer protocol used to establish membership in a multicast
group - it is not used to carry user data. Refer to RFC 1112 and RFC 2236 for information on IGMP versions 1 and
2 respectively.
Routing Protocol

Figure 19-2 RIP

Table 19-3 RIP

DESCRIPTION
Dimension ES-4024 Ethernet Switch
19-3