Buell 2002 P3 Service Manual page 358

Table of Contents

Advertisement

HOME
System Relay
See
Figure 7-35.
The system relay is in the relay block which
is located on the left side under the seat. Test the relay as fol-
lows:
1.
Remove seat. See
2.28
2.
Unplug relay from connector. See
TESTS.
3.
Test the relay in the same fashion as the starter relay.
See
5.6 STARTER SYSTEM
4.
Replace the relay with a new relay if necessary. Install
relay to frame with new rivet and washer.
Starter Relay
The starter relay is located on the right side of the motorcy-
cle, underneath the seat by the flasher relay.
Main Circuit Breaker
See
Figure 7-36.
Attached to the frame above the battery, the
main circuit breaker is between the ignition key switch and
the battery. Remove the main circuit breaker as follows:
1.
Remove seat. See
2.28
2.
Disconnect battery negative cable from battery.
3.
See
Figure 7-37.
Remove acorn nuts, nuts with lock
washers and wire leads from circuit breaker studs. Tag
wire leads for ease of assembly.
4.
See
Figure 7-36.
Remove circuit breaker from circuit
breaker bracket by carefully prying tab, located on left
side, open and sliding circuit breaker out. NOTE: Bank
Angle Sensor will require reinstallation if bracket is
removed. See
7.5 BANK ANGLE SENSOR.
5.
Install in the reverse order. Tighten screw (if bracket was
removed) to 25-27 in-lbs (2.8-3.1 Nm). Tighten metal nut
to 15-18 in-lbs (1.7-2 Nm). Tighten plastic acorn nuts to
1-3 in-lbs (0.1-0.3 Nm).
Ignition Fuse
See
Figure 7-38.
The ignition fuse is in the fuse block under
the seat. Always replace the fuse with another 7.5 ampere
fuse.
7803
Figure 7-35. System Relay
SEAT.
"ON-MOTORCYCLE"
TESTING.
SEAT.
System
Relay
Connector [171]
7811
Figure 7-36. Circuit Breaker
a0237x7x
Circuit Breaker (30A)
Nut with Lock washer (2)
Acorn Nut (2)
15-18 in-lbs
(1.7-2 Nm)
1-3 in-lbs
(0.1-0.3 Nm)
Figure 7-37. Circuit Breaker Installation
a0234x7x
TN/Y
TN/W
TN
[61]
Figure 7-38. Fuse Block
2002 Buell P3: Electrical
Bracket
Tab
Circuit Breaker (30A)
Bracket
Screw
25-27 in-lbs
(2.8-3.1 Nm)
O
R2
TN/Y
TN/GR
R/BK
7-31

Advertisement

Table of Contents
loading

This manual is also suitable for:

Buell blast p3 2001

Table of Contents