HOME
2.
Test the switch using an ohmmeter.
a.
With clutch engaged (1) (switch open), the switch
should show ∞ ohms (infinite ohms).
b.
With clutch disengaged (2) (switch closed), the
switch should show 0 ohms or little resistance.
3.
Replace the assembly with a new switch if necessary.
a.
Remove small Phillips screw.
b.
Depress clutch lever and hold.
c.
Detach switch by depressing switch trigger button
and pulling switch towards the end of the handlebar.
d.
Install new switch.
NOTE
To test/replace the neutral switch, see
CATOR
SWITCH.
7-30
2002 Buell P3: Electrical
7.23 NEUTRAL INDI-
a0230x7x
Screw (2)
30-36 in-lbs
(3.3-4.1 Nm)
Sidestand
Switch
Nut (2)
Figure 7-33. Side Stand Switch
a0231x7x
1
2
3
1.
Clutch Engaged (switch open)
2.
Clutch Disengaged (switch closed)
3.
Connector [95]
Figure 7-34. Clutch Switch
Connector [60]
Trigger
Button