Auto Enrichener - Buell 2002 P3 Service Manual

Table of Contents

Advertisement

HOME

AUTO ENRICHENER

GENERAL
See
Figure 7-15.
The auto enrichener controls the cold idle
speed of the motorcycle at startup and enriches the air/fuel
mixture. It is located on the carburetor. The auto enrichener is
not repairable. Replace the unit if it fails.
NOTE
In extreme cold ambient conditions, auto-enrichener may
remain on for longer periods of time.
Normal function of the auto enrichener is typically 2-5 minute
fast idle speed enrichment cycle, even after hot restart. If
enrichment cycle exceeds 5 minutes, see diagnostic chart on
following page.
See
4.5 AUTO-ENRICHENER
the auto enrichener.
See diagnostic chart on next page for troubleshooting infor-
mation.
NOTE
Auto-Enrichener wire colors may vary from those listed in
ure 7-15.
7-16
2002 Buell P3: Electrical
for information on replacing
Fig-
a0225x7x
Auto Enrichener
Tamper-Resistant
T20 TORX Screws
13-23 in-lbs
(1.5-2.6 Nm)
AUTO-ENRICHENER/TP SENSOR CONNECTOR [88]
CHAMBER
WIRE COLOR
NUMBER
1
Violet/Orange Auto-Enrichener
2
Orange
3
Light Blue
4
Yellow
5
Black
6
Figure 7-15. TP Sensor/Auto-Enrichener Connector [88]
7.7
Connector [88]
Throttle Position
Sensor
FUNCTION
Auto-Enrichener
TP Sensor Output
TP Sensor Input
TP Sensor Ground
Not Used

Advertisement

Table of Contents
loading

This manual is also suitable for:

Buell blast p3 2001

Table of Contents