Buell 2002 P3 Service Manual page 220

HOME
NOTE
See Figure 3-129. Use SPROCKET SHAFT BEARING
OUTER RACE INSTALLATION TOOL (Part No.
to install left and right outer races of sprocket shaft tapered
roller bearings into left crankcase half. Always install left outer
race prior to installing right outer race because the installer
base is usable only when you follow this sequence of race
installation.
2. Insert "SPORTSTER" end of installer base into inboard
side of left crankcase half bearing bore until base con-
tacts installed retaining ring.
3. Position left outer race over bearing bore on outboard
side of left crankcase half.
4. Insert shaft of installer plug through left outer race and
into installer base. Press race into bore until firmly
seated against retaining ring.
5. Insert "SPORTSTER" end of installer base into outboard
side of left crankcase half bearing bore until base con-
tacts outboard surface of installed left outer race.
6. Position right outer race over bearing bore on inboard
side of left crankcase half.
7. See Figure 3-129. Insert shaft of installer plug through
right outer race and into installer base. Press race into
bore until firmly seated against retaining ring.
NOTE
See Figure 3-129. Use SPROCKET SHAFT BEARING/SEAL
INSTALLATION TOOL (Part No. HD-42579) to install
sprocket shaft tapered roller bearings and seal.
8. See Figure 3-129. Install inner bearing.
a. Place new bearing, small end upward, over end of
sprocket shaft.
b. Thread pilot onto sprocket shaft until pilot bottoms
on sprocket shaft shoulder.
c. Sparingly apply graphite lubricant to threads of pilot
shaft to ensure smooth operation.
d. Slide sleeve over pilot until sleeve contacts inner
bearing race. Install Nice bearing, washer and han-
dle on top of sleeve.
e. Rotate handle clockwise until bearing contacts fly-
wheel shoulder. Remove tool from sprocket shaft.
7710
HD-39458)
Figure 3-129. Left Outer Race Bearing Installation
7711
Figure 3-130. Right Outer Race Bearing Installation
2002 Buell P3: Engine 3-73