Buell 2002 P3 Service Manual page 215

HOME
14. See Figure 3-121. Installed inner races are identified at
the factory as shown.
15. See Figure 3-122. Outer races are identified at the fac-
tory as shown.
NOTE
The different sizes of crankcase sets and flywheel assem-
blies will not have separate part numbers. That is, a replace-
ment crankcase set may have a class 1, 2 or 3 pinion outer
race. Replacement flywheel assemblies will have either a
class A or B inner race.
16. See Figure 3-123. Pinion bearings are identified as
shown.
BEARING SELECTION
See Table 3-15. Pinion Shaft Bearing Selection.
ings using the identification information given for inner and
outer races and bearings.
NOTE
If either inner or outer race show wear, measure both races to
confirm correct bearing fit.
a0131x3x
Paint Dot
RACE OD
1.2498-1.2500 in.
(31.7449-31.7500 mm)
1.2496-1.2498 in.
(31.7398-31.7449 mm)
* Paint dot on end of spline
SERVICE WEAR LIMIT: 1.2492 in. (31.7297 mm)
Figure 3-121. Factory Inner Race Sizes
3-68 2002 Buell P3: Engine
Select bear-
Inner
Race
CLASS IDENTIFICATION*
A White
B Green
a0134x3x
ID
RACE ID
1.5646-1.5648 in.
(39.7408-39.7459 mm)
1.5648-1.5650 in.
(39.7459-39.7510 mm)
1.5650-1.5652 in.
(39.7510-39.7561 mm)
* Stamped number inside crankcase near race
SERVICE WEAR LIMIT: 1.5672 in. (39.8069 mm)
Figure 3-122. Factory Outer Race Sizes
a0133x3x
A – Roller OD cannot be
ROLLER OD (A)
Largest
Smallest
* Package color
Figure 3-123. Bearing Identification
Outer Race
Right Crank-
case Half
Stamped
Class No.
CLASS STAMPED
NO. IDENTIFICATION*
1 1
2 2
3 3
measured to required
accuracy with
micrometer
IDENTIFICATION*
Red
Blue
White (Grey)
Green