Buell 2002 P3 Service Manual page 165

HOME
12. See Figure 3-30. Tighten hose clamps using Hose
Clamp Pliers, part no. HD-41137.
13. See Figure 3-31. Tighten nut on hose routing clamp.
14. Install rear shock. See 2.15 REAR SHOCK
15. See Table 3-4. Electrical Items for Engine Assembly
Connect the following electrical items:
Item
Description
no.
1 Ignition module [10]
2 Speedo sensor [65]
3 Side stand switch [60]
4 Neutral switch [131]
5 Oil pressure switch [120]
6 Alternator stator [46]
7 Starter solenoid wire
[128]
8 Spark plug wire
9 Battery—positive wire
10 Rear brake light switch
[121]
3-18 2002 Buell P3: Engine
ABSORBER.
Table 3-4. Electrical Items for Engine Assembly
Located on frame backbone.
Located under seat (right side-tucked in under cavity).
Tie wrapped to rear brake line.
Disconnect at neutral switch.
Disconnect at oil pressure switch.
Located under seat (left side).
Disconnect at starter.
Located on spark plug.
Disconnect at main circuit breaker.
Located under frame by shock absorber.
7635
Figure 3-30. Tighten Hose Clamps
7718
Figure 3-31. Tighten Clamp
Location