Buell 2002 P3 Service Manual page 334

HOME
YES
Install 6-place Harness Adaptor (HD-42962) and
Breakout Box using Black connectors between
connectors [10A] and [10B].
Measure Voltage between Pin 4 (PK) and Pin 6
(BK).
Is Voltage 12V +/- 1.0VDC?
YES
• Disconnect Ignition Module connector [10] from
Breakout Box.
• Ignition On.
• Jumper Wire – Connect Capacitor Wire To Ter-
*
minal 4 (PK).
• Connect Both Wires To Common Ground (6).
• Momentarily touch Ground Wire To Terminal 4
(PK) at Breakout Box.
Is There A Spark At Plug When You Remove
The Wire?
*
Perform Coil Resis-
tance Check If Capaci-
tor Is Not Available
YES
• Reconnect ignition module connector [10] to
Breakout Box
• Ignition Switch On.
• Multimeter Red Lead To (W/BK) Wire (Pin 1)
Terminal.
• Multimeter Black Lead To BK (Pin 6) On [10B].
• Multimeter Should Register 12VDC ± 1.0 VDC.
YES
Go To Next Page
Use harness connector
1
adaptor kit (HD-41404)
gray female probe(s) and
patch cord.
NOTE
Male connectors are labeled "A"
Female connectors are labeled "B"
NO
Check resistance between
1
terminals A and B on coil [83A].
Resistance should be 0.4-0.6 ohms.
Is it?
YES
Repair Open
on PK wire.
5003
Replace coil.
1
Check resistance between secondary
(plug wire) terminal and C terminal on
coil. Resistance should be between
7720 and 9440 ohms. Is it?
YES
Check Spark Plug cable
resistance. Is resistance
between 2375 and 5833
ohms?
NO
Check Continuity Between
Pin 1 W/BK [10B] And Coil
W/BK Wire.
Continuity Present?
YES
Repair Open Between [10B]
Pin 6 (BK) And Ground
5003
Figure 7-5. No Spark At Spark Plug
NO
5010
NO
NO
Replace Coil.
5012
NO
YES
Repair open. Replace
Ground wire Spark Plug
to coil. Cable
5000
NO
Repair Open In W/BK Wire
2002 Buell P3: Electrical
W/BK
+
W/BK
PK
-
W/BK
W/BK
PK
+
Jumper
-
Coil
[83A]
C B A
[10]
1 6
2 5
3 4
Note: See Chart
on p. 7-16 for
pin functions.
5051
5003
7-7