Buell 2002 P3 Service Manual page 169

HOME
27. See Figure 3-41. Install front isolator mounting bolt,
spacer snubber and new nut.
28. Tighten front isolator mounting bolt to 63-70 ft-lbs (86-95
Nm).
29. See Figure 3-42. Install crankcase breather hose and
crankcase breather into rocker box grommet.
30. Install horn. See 7.22 HORN.
31. Remove jack from under the motor.
32. Install muffler. See 2.20 EXHAUST
33. Install fuel tank. See
TANK.
34. Install new oil filter, engine oil and primary chaincase
fluid as necessary.
35. See Figure 3-33. Install right side rider footpeg bracket
assembly. See 2.21 FOOTPEGS AND FOOTPEG SUP-
PORT BRACKETS.
11 1
WARNING
Always connect positive battery cable first. If the positive
cable should contact ground with the negative cable
installed, the resulting sparks may cause a battery explo-
sion which could result in death or serious injury.
36. Connect both battery cables, positive cable first. See
7.16 BATTERY.
37. Install seat. See 2.28 SEAT.
3-22 2002 Buell P3: Engine
SYSTEM.
4.2 FUEL TANK COVER/FUEL
WARNING
a0162x6x
7
6
5
4
1. Frame
2. Locknut
3. Snubber
4. Bolt
5. Spacer
6. Front Isolator
7. Standoff
Figure 3-41. Front Isolator Mount
7629
Figure 3-42. Install Crankcase Breather Hose
1
3 2