Buell 2002 P3 Service Manual page 210

HOME
5. See Figure 3-112. Install gearcase cover over all gears
and onto right crankcase half. Secure cover to crankcase
half with 7 socket head screws. Tighten screws evenly to
80-110 in-lbs (9-12 Nm). Use torque sequence as
shown in Figure 3-112.
6. See Figure 3-113. Check cam gear end play for each
cam gear as follows:
a. Turn engine over until lobe of cam gear being
checked is pointing toward its respective tappet
guide hole.
b. Gently pry the cam gear toward the gearcase cover
using a flat blade screwdriver.
c. Measure gap between bushing (in crankcase half)
and cam gear shaft thrust face (shoulder) using a
feeler gauge. This is cam gear end play.
d. Compare cam gear end play measurements with
the SERVICE WEAR LIMITS. Make repairs as
required if end play does not meet specifications.
7. See 3.15 HYDRAULIC
and push rods.
8. Install cam position sensor and rotor in gearcase cover.
7.8 IGNITION MODULE/ CAM POSITION
9. Install any components removed to gain access to gear-
case (i.e. exhaust system components, air cleaner, etc.).
LIFTERS. Install hydraulic lifters
SENSOR.
7696
6
7
5 2
Figure 3-112. Gearcase Cover Mounting Screw
Torque Sequence
7683
Figure 3-113. Checking Cam Gear End Play
2002 Buell P3: Engine
3
1
4
3-63