Buell 2002 P3 Service Manual page 158

HOME
Table 3-3. Electrical Items Disconnected for Engine Disassembly
Item
Description
no.
1 Ignition module [10]
2 Speedo sensor [65]
3 Side stand switch [60]
4 Neutral switch [131]
5 Oil pressure switch
[120]
6 Alternator stator [46]
7 Starter solenoid wire
[128]
8 Spark plug wire
9 Battery—positive wire
10 Rear brake light switch
[121]
24. See Figure 3-11. Place a floor hoist behind the lift.
Attach straps to frame and hoist. Raise hoist until straps
tighten.
25. Remove rear shock.
ABSORBER.
26. See Figure 3-12. Loosen nut on hose routing clamp.
Located on frame backbone.
Located under seat (right side-tucked in under cavity).
Tie wrapped to rear brake line.
Disconnect at neutral switch.
Disconnect at oil pressure switch.
Located under seat (left side).
Disconnect at starter.
Located on spark plug.
Disconnect at main circuit breaker.
Located under frame by shock absorber.
See 2.15 REAR SHOCK
Location
7650
Figure 3-11. Hoisting Bike
7718
Figure 3-12. Loosen Clamp
2002 Buell P3: Engine 3-11