Buell 2002 P3 Service Manual page 124

HOME
a. Position fork tubes so that top of each slider tube is
flush with the top surface of upper triple clamp. Be
sure that top surface of fork is not below top surface
of upper triple clamp.
b. Tighten upper triple clamp pinch screws (at sliders)
to 13-16 ft-lbs (18-22 Nm).
c. Tighten lower triple clamp pinch screws to 22-29 ft-
lbs (30-39 Nm).
d. See Figure 2-89. Tighten head lamp brackets flush
against bottom of top triple clamp.
4. Install front fender. See
5. Install front wheel. See
6. Install front brake caliper. See
CALIPER.
7. Align head lamp. See 7.17
2.23 FENDERS.
2.5 FRONT WHEEL.
2.11 FRONT BRAKE
HEADLAMP.
3765
Upper
Triple
Clamp
Lower
Triple
Clamp
Figure 2-88. Pinch Screws
a0065aSx
Figure 2-89. Tighten Head lamp Bracket
2002 Buell P3: Chassis
Headlamp Bracket
Screws
2-49