Rear Wheel Removal - Honda GL1100 Owner's Manual

REAR WHEEL REMOVAL
1. Place the motorcycle on its center
stand.
2. Support the fear wheel so it will not
drop when the shock absorbers are dis·
connected.
3. Remove the cotter pin (I) from the
axle and remove the axle nut (2).
4. Remove the axle holding bolt (3) and
brake disc dust cover (4).
5. Remove the lower shock absorber nut
(5: right side) and bolt (6: left side).
6. Raise the rear wheel so the axle will
clear the muffler.
(l)
Colter pin (2) Axle nut
(5) Lower shock absorber nut
7. Pull out the rear axle (7).
CAUTION:
,. Support the caliper assembly and swing-
arm before removing the rear axle so
that it does not hang from the brake
hose. Do not twist the brake hose.
8. Remove three final drive case nuts (8).
9. Move the wheel backward.
10. Separate the final drive case from the
wheel.
(3) Axle holding bolt (4) Dust cover
(6) Lower shock absorber bolt
(7) Rear axle
(8) r:inal drive case nuts
CAUl
• Do
Th
b,1
II.
NOTI
• Dr
thl
cal
cy
flo
bn
au