Standard Network Software Error [54]; Standard Usb Port Disabled [56]; Supply Needed To Complete Job; The Device Is Operating In Safe Mode. Some Print Options May Be Disabled Or Provide Unexpected Results - Lexmark MS911 Service Manual

Standard network software error [54]

Try one or more of the following:
•
From the printer control panel, touch Continue to continue printing.
•
Turn off the printer, and then turn it back on.
• Update the network firmware in the printer or print server. For more information, visit the Lexmark support Web
site at http://support.lexmark.com

Standard USB port disabled [56]

Try one or more of the following:
•
From the printer control panel, touch Continue to clear the message.
•
Enable the USB port. From the printer control panel, navigate to:
Network/Ports > USB Buffer > Auto
Note: The printer discards any data received through the USB port.

Supply needed to complete job

Do either of the following:
•
Install the missing supply to complete the job.
•
Cancel the current job.
The device is operating in Safe Mode. Some print options may be disabled or
provide unexpected results.
Touch Continue on the control panel to clear the message and continue printing.

Too many flash options installed [58]

Try one or more of the following:
•
Touch Continue on the control panel to continue printing.
•
Remove the extra flash memory:
1
Turn off the printer.
2
Unplug the power cord from the electrical outlet.
3
Remove the extra flash memory.
4
Connect the power cord to a properly grounded electrical outlet.
5
Turn the printer back on.

Too many trays attached [58]

1
Turn off the printer.
2
Unplug the power cord from the electrical outlet.
or contact customer support, and then report the message.
Diagnostic information
49
4021, 7421