Fax Station Name not set up. Contact system administrator.
Try either of the following:
•
From the printer control panel, touch Continue to clear the message.
•
Complete the Analog Fax setup. If the message appears again after completing the setup, then contact your system
support person.
Fax Station Number not set up. Contact system administrator.
Try one or more of the following:
•
From the printer control panel, touch Continue to clear the message.
•
Complete the Analog Fax setup. If the message appears again after completing the setup, then contact your system
support person.
Incorrect paper size, open [paper source] [34]
Try one or more of the following:
•
Load the correct paper size and type in the tray or feeder, and then specify the paper size and type in the Paper
menu on the control panel.
•
Make sure that the correct paper size and type are specified in Print Properties or the Print dialog settings.
•
Check the length and width guides and make sure that the paper is loaded properly in the tray or feeder.
•
From the control panel, touch Continue to clear the message and then print using a different tray.
•
Touch Reset active bin to reset the active bin for a linked set of bins.
•
Cancel the print job.
Insert hole punch box
Insert the hole punch box into the finisher, and then touch Continue to clear the message.
Insert Tray [x]
Try one or more of the following:
•
Insert the specified tray into the printer.
•
Cancel the print job.
•
Reset the active bin for a linked set of bins by selecting Reset active bin on the printer control panel.
Insufficient memory for Flash Memory Defragment operation [37]
Try one or more of the following:
•
From the printer control panel, touch Continue to stop the defragmentation and continue printing.
•
Delete fonts, macros, and other data in the printer memory.
•
Install additional printer memory.
Diagnostic information
39
4021, 7421