Some Held Jobs Were Not Restored; Standard Network Software Error [54]; Standard Usb Port Disabled [56]; Supply Needed To Complete Job - Lexmark MX610 Service Manual

Some held jobs were not restored

From the printer control panel, touch Continue to delete the indicated job.
Note: Held jobs that are not restored remain in the printer hard disk and are inaccessible.

Standard network software error [54]

Try one or more of the following:
• From the printer control panel, touch Continue to continue printing.
•
Turn off the printer, and then turn it back on.
•
Update the network firmware in the printer or print server. For more information, contact customer support.

Standard USB port disabled [56]

Try one or more of the following:
•
From the printer control panel, touch Continue to clear the message.
• Enable the USB port. From the printer control panel, navigate to:
Network/Ports > USB Buffer > Auto
Note: The printer discards any data received through the USB port.

Supply needed to complete job

Do either of the following:
• Install the missing supply to complete the job.
•
Cancel the current job.

Too many flash options installed [58]

1
Turn off the printer.
2
Unplug the power cord from the electrical outlet.
3
Remove the extra flash memory.
4
Connect the power cord to a properly grounded electrical outlet.
5
Turn the printer back on.

Too many trays attached [58]

1
Turn off the printer.
2
Unplug the power cord from the electrical outlet.
3
Remove the extra trays.
4
Connect the power cord to a properly grounded electrical outlet.
5
Turn the printer back on.
Diagnostic information
101
7016