Shpf Compiler Feed Jam Service Check - Lexmark MS911 Service Manual

Action
Step 12
a
Check the diverter, diverter lever, and diverter spring for wear or
damage, and replace if necessary. See
on page 587.
b
Check the diverter cam for wear or damage, and replace if necessary.
See "SHPF diverter cam removal" on page
Does the problem remain?
Step 13
a
Reseat the interface cable on the SHPF controller board and printer.
b
Reseat the junction connector on the cable.
c
Check the cable for damage, and replace if necessary.
Does the problem remain?
Step 14
a
Reseat all the cables on the booklet maker controller board.
b
Reset the printer.
Does the problem remain?
Step 15
Replace the controller board. See
removal" on page 462.
Does the problem remain?

SHPF compiler feed jam service check

Action
Step 1
a
Remove any debris from the paper path.
b
Reseat the interface cable plugged into the printer.
c
Reset the printer.
Does the problem remain?
Step 2
a
Test the sensor (SHPF compiler feed).
Enter the Diagnostics menu, and then navigate to:
SENSOR TESTS > Staple and Hole Punch Finisher Sensor Tests
b
Toggle the sensor.
Does the status of the sensor change after toggling it?
"SHPF—Transport section 4"
391.
"Booklet maker controller board
Diagnostic information
91
Yes No
Go to step 13. The problem is solved.
Go to step 14. The problem is solved.
Go to step 15. The problem is solved.
Contact the next level The problem is solved.
of support.
Yes No
Go to step 2. The problem is solved.
Go to step 6. Go to step 3.
4021, 7421