Table of Contents
Advertisement
)
)
Steering
Ignition Switch Assembly - Assemble -
Off Vehicle
Assembly Procedure
1. Install the vehicle wire harness into the ignition
switch assembly (2).
2. Install the ignition switch assembly (2) to the
ignition switch actuator assembly.
3. Install the flat head screw (1) to the ignition switch
assembly (2).
4. Tighten the flat head screw (1) finger tight.
5. Move the ignition switch assembly slider (2) to the
far right position.
6. Move the ignition switch assembly slider (2)
detent to the left. This is the OFF LOCK position.
7. Install a 3/32 inch drill bit into the hole on
the ignition switch assembly (1) to limit travel.
8 .. Push against the ignition switch actuator assembly
to limit all the lash.
Notice:
Refer to Fastener Notice in Cautions and
Notices.
9. Install the flat head screw.
Tighten
Tighten the screw to 4 N·m (35 lb in).
10.
Install the dimmer switch assembly. Refer to
Dimmer Switch Assembly - Assemble - Off
Vehicle.
Dimmer Switch Assembly - Disassemble -
Off Vehicle
Disassembl Procedure
Tools
Required
J
41352 Modular Column Holding Fixture
1. Insert the steering column and
J
41352 into
a vise.
2. Rel')'love-the hexagon washer head tapping
screw (1) from the dimmer switch assembly (3) .
3, . Remove the washer head screw (2) from the
dimmer switch assembly (3).
4. Remove the dimmer switch rod from the dimmer
switch assembly (3).
5. Remove the dimmer switch assembly (3) from the
ignition switch assembly (4).
6. Remove the dimmer switch assembly (3) from the
vehicle wire harness.
Steering Wheel and Column - Tilt 2-75
393976
2
358702
3
393978
Advertisement
Chapters
Table of Contents
