GMC chevrolet camaro 2000 Service Manual page 232

)
HVAC
7. Install the left side insulator. Refer to
Closeout/Insulator Panel Replacement - Left in
Instrument Panel, Gauges and Console.
8. Install the right side insulator. Refer to
Closeout/Insulator Panel Replacement - Right in
Instrument Panel, Gauges and Console.
Vacuum Actuator Replacement
Removal Procedure
1.
Remove the instrument panel (IP) carrier. Refer to
IP Carrier Replacement in Instrument Panel,
Gauges and Console.
2. Remove the front floor air duct. Refer to Air Outlet
Replacement - Floor.
3. Remove the air distributor case face (1) and
seal (2).
4. Disconnect the vacuum hose from the vent mode
valve actuator (4).
5. Remove the vent mode valve linkage screw (5).
6. Unsnap the vent mode valve actuator (4) from air
distributor case.
Installation Procedure
i.
Snao the vent mode valve actuator (4) to the air
distributor case.
Notice: Refer to Fastener Notice in Cautions and
Notices.
2. Install the vent mode valve linkage screw (5).
Tighten
Tighten the vent mode valve actuator screw to
2 N-m (18 lb in).
3. Connect the vacuum hose to the vent mode valve
actuator (4).
4. Install the air distributor case face ( 1) and
seal (2).
5. Install the front floor air duct. Refer to Air Outlet
Replacement - Floor.
6. Install the IP carrier. Refer to IP Carrier
Replacement in Instrument Panel, Gauges and
Console.
HVAC Systems - Manual 1-135
571441
571441