)
\
)
I
Brakes
3. If equipped with ABSffCS, install two wave
springs (1) between the EBCM and BPMV. Use
locations and orientation noted during removal.
Notice:
Refer to
Fastener Notice
in Cautions and
Notices.
4.
Install the EBCM
(1)
to the BPMV
(5).
Tighten
Tighten the top four mounting screws (2) to
2.9 N,m (26 lb in.). Tighten screws in an X pattern.
Tighten
Tighten the bottom two mounting screws (2) to
2.9 N·m (26 lb. in.).
5. Connect the pump motor connector (3) to the
bottom of the EBCM.
6. Connect the EBCM harness connector. Push in
lock tab.
7. Turn the ignition switch to the RUN position,
engine off.
8. Perform the
A Diagnostic System Check- ABS
Antilock Brake System 5-235
255236
3
4
213438
4
3
213428