Master Cylinder Replacement - GMC chevrolet camaro 2000 Service Manual

5-24 Hydraulic Brakes
451525
222987
222987
Master Cylinder Replacement
Removal Procedure
Brakes
1. Remove and discard the brake flLJid.from the
reservoir.
2. Remove the combination valve pipes in order to
prevent fluid loss and contamination.
3. Disconnect the brake fluid level sensor connector.
4. Remove the master cylinder nuts.
5.
Remove the master cylinder.
Installation Procedure
1. Bench bleed the master cylinder. Refer to Master
CyfinderBench Bleeding.
2. Install the master cylinder.
Notice: Refer to Fastener Notice in Cautions and
Notices.
3. Install the master cylinder nuts.
Tighten
Tighten the master cylinder nuts to
29 N-m (21 lb
ft).
4. Fill the master cylinder reservoir. Refer to Master
Cylinder Reservoir Filling.
5. Install the brake combination valve pipes onto the
master cylinder one at a time. Complete the
following steps:
5.1. Remove the locally fabricated plugs.
5.2. Install the brake pipe fitting finger tight.
(