Tilt Spring - Disassemble - Off Vehicle - GMC chevrolet camaro 2000 Service Manual

)
)
Steering
2. Put the steering column passkey lock cylinder
set (1) into the lock housing cover assembly.
Notice:
Refer to Fastener Notice in Cautions and
Notices.
3. Install the lock retaining screw (2).
Tighten
Tighten the screw to 2.5 N-m (22 lb in).
4. Install the buzzer switch assembly (3).
5. Install the retaining clip (4) onto the steering
column passkey lock cylinder set terminal lead
and the lock housing cover assembly.
6.
Install the turn signal switch assembly. Refer to
Turn Signal and Multifunction Switch Assembly -
Assemble - Off Vehicle.
Tilt Spring - Disassemble - Off Vehicle
Disassembly Procedure
Tool Required
J
39246 Tilt Spring Compressor
1. Remove the lock housing cover and sleeve
assembly. Refer to Lock Housing Assembly -
Disassemble - Off Vehicle.
Caution: The tilt spring and the spring guide are
under pressure. The tilt spring and the spring
guide may become a projectile. Secure the spring
with locking pliers during removal. Secure the
spring with locking pliers during installation.
Bodily injury may result during removal and
installation of the tilt spring and the spring guide.
Always use caution during removal and
installation of the tilt spring and the spring guide.
2. Seat the counterbore of
J
39246 over the
steering shaft assembly (1 ).
3. Thread and seat the standard hexagon nut of the
tool onto the steering shaft assembly (2).
4. Thread the hexagon nut of the tool until it contacts
the block of
J
39246. ·
Steering Wheel and Column - Tilt 2-79
343829
1
343839