Ignition Switch Assembly - Disassemble; Ignition Switch Assembly - Assemble - GMC chervolet camaro 1999 Service Manual

2-82 Steering Wheel and Column - Tilt
· " ' - ~ 1
~
\,
\
354116
393976
393976
Steering
8. Pull the turn signal switch assembly connector
towards the base of the column.
9. Insert the wiring protector into the steering
column bracket.
10. Insert the steering column wire harness into the
steering column wire harness strap.
11. Install the turn signal cancel cam assembly.
Refer to Turn Signal Cancel Cam, Upper
Bearing Inner Race Assemble - Off Vehicle.
12. Install the tilt lever. Refer to Tilt Lever
Replacement- On Vehicle.
13. Install the multifunction lever. Refer to
Multifunction Tum Signal Lever Replacement -
On Vehicle.
14. Install the hazard knob. Refer to Hazard Warning
Switch Replacement - On Vehicle.
Ignition Switch Assembly - .Disassemble
Disassembly Procedure
1 . .Remove the dimmer switch assembly. Refer to
Dimmer Switch Assembly - Disassemble.
2. Remove the flat head screw (1) from the ignition
switch assembly (2).
3. Slide the vehicle wire harness from the ignition
switch assembly (2).
4. Remove the ignition switch assembly (2) from the
ignition switch actuator assembly.
5. Remove the ignition switch assembly (2) from the
steering column jacket assembly.
Ignition Switch Assembly - Assemble
Assembly Procedure
1. Install the vehicle wire harness into the ignition
switch assembly (2).
2. Install the ignition switch assembly (2) onto the
steering column jacket assembly.
3. Install the ignition switch assembly (2) to the
ignition switch actuator assembly.
4. Install the flat head screw (1) to the ignition switch
assembly (2).
5. Tighten the flat head screw (1) finger tight.
(
(
(