GMC chevrolet camaro 2000 Service Manual page 491

5-18 Hydraulic Brakes Brakes
Brake Warning Indicator Inoperative
Step Action Value(s) Yes
No;
Did you review the system operation and perform the Go to Symptoms
1
necessary inspections?
-
- Hydraulic
Go to Step.2 Brakes
1. Turn the ignition to the RUN position. Go to Testing for
2. Set the park brake.
Intermittent and
2
Does the brake warning indicator illuminate?
-
Poor Connections
in Wiring
Systems . Go to Step 3
3
Did the brake warning indicator illuminate for the bulb test
-
and then turn off? Go to Step 4 Go to Step 10
i. Disconnect the brake fluid level indicator sensor.
2. Connect a 1 OA fused jumper from the brake fluid
4
level indicator sensor connector terminal A to
terminal B. Refer to Circuit Testing in Wiring Systems.
-
3. Turn the ignition switch to the RUN position.
Is the brake warning indicator on? Go to Step 5 Go to Step 7
Test for and repair a poor connection at the brake fluid
level indicator sensor. Refer to Testing for Intermittent and
5
Poor Connections and Connector Repairs in Wiring -
Systems.
Did you find and repair a poor connection? Go to Step 23 Go to Step 6
Replace the brake fluid level indicator sensor. Refer to
6
Master Cylinder Fluid Level Sensor Replacement.
-
-
Did you complete the replacement? Go to Step 23
1. Connect a 1 OA fused jumper from the brake fluid
level indicator sensor terminal A to ground. Refer to
(
7
Circuit Testing in Wiring Systems.
-
2. Turn the ignition switch to the RUN position.
Is the brake warning indicator on? Go to Steps Go to Step 9
..
Repair the open in circuit 150 between the brake fluid level
8
indicator sensor terminal B and 8155. Refer to Wiring
Repairs in Wiring Systems.
- -
Did you complete the repair? Go to Step 23
Repair the open or poor connection in circuit 33 between
the brake fluid level indicator sensor terminal A and 8228.
9
Refer to Wiring Repairs or Connector Repairs in Wiring
-
-
Systems.
Did you complete the repair? Go to Step23
Replace the instrument cluster. Refer to IP Cluster
10
Replacement in Instrument Panel, Gauges, and Console.
-
-
Did you complete the replacement? Go to Step23
1. Disconnect the park brake switch connector.
2. Connect a 1 OA fused jumper from the park brake
11
switch connector to ground. Refer to Circuit Testing in
Wiring Systems.
-
.,
..
3. Turn the ignition switch to the RUN position.
Is the brake warning indicator on? Go to Step 12 Go to Step 15
Test for and repair a poor connection at the park brake
12
switch. Refer to Testing for Intermittent and Poor
-
Connections and Connector Repairs in Wiring Systems.
Did you find and repair a poor connection? Go to Step 23 Go to Step 13