Torque Arm Replacement - GMC chevrolet camaro 2000 Service Manual

Suspension
Installation Procedure
J
Tools Required
• J 21474-5 Bushing Receiver
• .J 21474-20 Front and Rear Bushing Installer
1. lnstaH J 21474-5 over the flanged side of the
bushing.
2. Install the bushing into position using J 21474-20.
3. Install the lower control arm. Refer to Rear Axle
Lower Control Arm Replacement.
4. Remove the rear axle support.
5. Lower the vehicle.
Torque. Arm Replacement
Removal Procedure
Important: When raising the vehicle, support the
vehicle by the frame, allowing the suspension to fully
extend (unloaded).
1. Raise and suitably support the vehicle. Refer to
Lifting a.n.d Jacking the Vehicle in General
Information.
2. Support the rear axle with an adjustable
jack stand.
3. Remove the center support bearing (2) bolts from
the torque arm (1 ), if equipped with a two-piece
propeller shaft only.
4. Remove the torque arm bolts (2), washers (3) and
nuts (4) from the .rear axle (1 ).
Rear Suspension 3-47
J 2i470-20
I
1
J 21474-5
181233
1
483066
181239