Dimmer .Switch Assembly - .Assemble; Off Vehicle - GMC chevrolet camaro 2000 Service Manual

2-76 Steering Wheel and"'Column-:'f..ilt
393978
393978
Steering
Dimmer Switch Assembly·.- Assemble ·
Off Vehicle
Assembly Procedure
Tools Required
J 41352
.Modular Column Holdtng Fixture
1. lnstaU the dimr:ne.r. S'!Vitch assembly (3) to the
ignition switch assembly (4). ·
2.
lnstallth13 he~agon w~~her hea.d tapping screw (1)
.to. the dimmer switch assembly (3).
3 ..
Tight~nthe.hexagon washer head tapping
screw (1)fjnger tight. ·
4. In.stall the washer head screw (2) to the dimmer
.. switch assembly (3).
5.
Tighten.the washer head screw
(2)
finger tight.
6.
Insert the dimrner switch rod into the slot on
the dimrner switch.assembly (3).
7 .. Adjust the dimmer: switch; assembly following
these steps: · . .
. 7: 1. Install a '3132 in'ch drill bit into the hole (1)
· on the dimmer switch· assembly to limi1
travel.
7.2, ..
.Position .the c;:lin,mer switch assembly onto
· · the cqlumn a.rid push it against the dimmer
switch· actuator rod to remove all the· ,ash.
7.3. Remove the drill bit.
Notic~:. ReferJo Fastener NotiQe in Cautions and
Notices.
8. lnstali the h~xagon washer head screw (1).
Tighten .
Tighten the hexagon washer' head· screw to
2.5
N-m
(22
lb
inf' · ·· .· ·
9. lnstallth~'washer head screw (2) ..
Tighten
Tighten the washer head screw to 4 N-m (35 lb in).
1 O. Insert the vehicle wire harness into the dimmer
switch assembly (3).
11. Remove the steering column and
J 41352
from
the vise.
(
(