GMC chevrolet camaro 2000 Service Manual page 184

HVAC Heating, Ventilation and Air Conditjoning 1-87
6. Add the engine coolant:
• If the previously drained coolant is
uncontaminated, use the previously drained
coolant.
• If the previously drained coolant is
contaminated, discard the contaminated
coolant.
Then, add a fresh 50/50 DEX-COOL and water
mixture.
Blower Motor Relay Replacement
Removal Procedure
1. Remove the driver side instrument panel (IP)
insulator. . Refer to Closeout/Insulator Panel
Replacement - Left in Instrument Panel, Gauges
and Console.
2. Remove the knee bolster. Refer to Knee Bolster
Replacement - Left in Instrument Panel, Gauges
and Console.
3. Remove the blower motor relay from the IP
tie bar.
4. Disconnect the electrical connector from the
blower motor relay.
Installation Procedure
1. Connect the electrical connector to the blower
motor relay.
2. Install the blower motor relay to the IP tie bar.
3. Install the knee bolster. Refer to Knee Bolster
Replacement - Left in Instrument Panel, Gauges
and Console.
4. Install the driver side IP insulator. Refer to
Closeout/lnsulatorPanel Replacement - Left
in Instrument Panel, Gauges and Console.
365453
365453