GMC chevrolet camaro 2000 Service Manual page 339

2-92 . Steering Wheel and Colu.mn - Tilt
306318
343889
569761
Steering
5. Lubricate the exposed area of the race and upper
shaft assembly (1).
Important: Use the marks on the race and upper
shaft assembly and the lower shaft assembly from the
disassembly procedure. Failure to assemble the
race and upper shaft assembly and the lower shaft
assembly correctly will cause the steering wheel to be
turned 180 degrees.
6. Align the mark on the race and upper shaft
assembly (1) to the mark on the lower steering
shaft assembly (2).
7. Tilt the race and upper shaft assembly (1)
90 degrees to the lower steering shaft
assembly (2) to engage.
8. Install the steering shaft assembly to the steering
column.
9. Install the following 4 items to the steering column
jacket assembly:
9.1. Install the lower bearing adapter (4).
9.2. Install the bearing assembly (3).
9;3, Install the bearing adapter retainer (2).
9.4. Install the lower bearing adapter clip (1).
10. Install. the pivot and pulse switch assembly only.
Refer to Windshield Wiper and Washer Switch
Assembly - Assemble - Off Vehicle.
11. Install the steering column housing assembly.
Refer to Steering Column Jacket - Assemble -
Off Vehicle.
(
(
(