GMC chevrolet camaro 2000 Service Manual page 560

)
)
Brakes
4. With the park brake lever (1)in the down position,
rotate the adjuster arm toward the front of the
vehicle until the adjuster arm stops.
5.
On the adjuster ratchet, bend the tab at the
barrel-shaped front cable end back in order
to allow the cable strand to pass by.
6.
Unhook cable front end button from adjuster
ratchet.
7. Remove the barrel-shaped front cable end fitting
from the adjuster track on the pulley.
8. Remove the park brake lever bolts (3) and the
park brake lever (1) from the floor pan.
9. Use the
J
37043 in order to remove the park
brake front cable (4) from the park brake
lever (1) and remove the lever from vehicle.
Installation Procedure
1. On the new park brake lever assemblies, pull the
lever up to full travel. Remove the adjuster
spring (2).
2.
Push out the plastic shear pin.
3. Install the park brake front cable (4) to the park
brake lever (1 ).
Notice: Refer to Fastener Notice in Cautions and
Notices.
4.
Install the park brake lever (1) and the park brake
lever bolts (3) to the floor pan.
Tighten
Tighten· the park brake lever bolts (3) to
12 N·m (1061b in).
5. Connect the electrical connector to the park brake
indicator switch (6).
6. With the park brake lev.er in the down position
and adjuster pawl released, rotate the adjuster
arm toward the front of the vehicle until the
adjuster arm stops.
7. Connect the barrel-shaped front cable end fitting
to the adjuster track on the pulley. ·
8. If the rear cables were not disconnected from the
equalizer, skip to step 12.
9. Raise the vehicle. Suitably support the vehicle.
Refer to Lifting and Jacking the Vehicle in
General Information.
10. Connect the rear cables (2) to the equalizer (1 ).
11. Lower the vehicle.
Park Brake 5-87
182184
214860