GMC chevrolet camaro 2000 Service Manual page 148

HVAC
Heating, Ventilation.and Air Conditioning 1-51
Notice: Do not support the rotor by resting the pulley
rim on a flat surface during the bearing installation
or the rotor face will be bent.
1. Place the pulley rotor on the J 21352-A in order to
fully support the rotor hub during the bearing
installation.
2. Align the new bearing with the hub bore.
3. Using the J 9481-A and the J 8092, drive the
bearing into the hub.
The J 9481-A applies force to the outer race of
the bearing.
4. Place the J 33019 and the staking pin in the
hub bore.
5. Shift the rotor and bearing assembly on the
J21352-A in order to fully support of the hub
under the location of the staking pin.
6. Use a heavy-duty rubber band (1) in order to hold
the stake pin in the guide of the J 33019.
Important: Do not allow a metal stake to contact the
outer face of the bearing in order to prevent.
distortion of the outer race.
7. Using care in order to prevent injury, strike the
staking pin of the J 33019. Properly position the
stake pin in the guide after each impact on the pin.
8. Continue to strike the pin of the J 33019 until
a
stake, similar to the original stake, is formed
down to, but not touching, the bearing.
9. Stake three places 120 degrees apart.
J 33019
210151
6147