GMC chevrolet camaro 2000 Service Manual page 333

2-86 Steering Wheel and Column - Tilt
354605
344138
569768
Steering
Important: If the steering column housing assembly
and the pivot pins (1) have been staked (2) 3 times it
must be replaced.
15. Install th.e steering. column housing assembly.
16. Install the steering column housing assembly
following these steps:
16.1. Install the tilt lever (2) and use it to pull
back on the steering column housing
assembly (1) to mount on the steering
column housing support assembly.
16.2. Position the steering column housing
assembly (1) onto the steering column (
housing support assembly. \
16.3. Align the switch actuator rack with the pin
on the end of the ignition switch actuator
assembly.
16.4. Pull back on the tilt lever (2) to position
the steering column housing assembly (1 ).
16.5. Push the steering column housing
assembly (1) into the steering column
housing support assembly.
16.6. Release the tilt lever (2) to lock the steering
wheel lock shoes and the dowel pin.
16.7. Remove the tilt lever (2).
17. Install 2 pivot pins .(1) and (2).
18. Press the 2 pivot pins (1) and (2) until they are
firmly seated.
19. Stake the pivot pins in 3 places.
20. Install the tilt spring assembly. Refer to Tilt Spring
- Assemble - Off Vehicle.