Table of Contents
Advertisement
11. install the seat belt and retractor in the reverse
order of removal, and note these items:
• Check that the retractor locking mechanism
functions (see page 23-17).
• Assemble the washers, collar and bushing on the
upper and lower anchor bolts as s h o w n .
• Before installing the anchor bolts, make sure
there are no twists or kinks in the front seat belt.
'01-02 models:
• Make sure the seat belt tensioner connector is
plugged in properly.
• Reconnect the negative cable to the battery.
• Enter the anti-theft code for the radio, then enter
the customer's radio station presets.
Upper anchor bolt construction:
U P P E R A N C H O R
U P P E R
T O O T H E D
B O L T
A N C H O R
L O C K W A S H E R
W A S H E R S
Lower anchor bolt construction:
L O W E R A N C H O R
B U S H I N G
B O L T
W A V E
W A S H E R
L O W E R
C
O
L
L
A
R
S
T O O T H E D
W A & n t H
A N C H O R
C O L L A R S
L O C K W A S H E R
Retractor bolt construction:
TOOTHED
LOCK WASHER
Front Seat Beit Replacement
Sedan
'01-02 models: SRS components are located in this area.
Review the SRS component locations (see page 23-23),
and precations and procedures (see page 23-28) in the
SRS section before preforming repairs or service.
NOTE: Check the front seat belts for damage, and
replace them if necessary. Be careful not to damage
t h e m during removal and installation.
Front Seat Belt
1. '01-02 models: Make sure y o u have the anti-theft
code for the radio, then w r i t e d o w n the frequencies
for the preset buttons.
2. Slide the front seat f o r w a r d fully.
3. '01-02 models: Disconnect the negative battery
cable, and wait at least 3 minutes before beginning
work.
4. Remove the rear seat cushion (see page 20-129).
5. Remove these items (see page 20-75):
• Front side t r i m
• Rear side t r i m
• Center pillar lower t r i m panel
6. Remove the upper anchor cover (A), and pull the
lower anchor cover (B) back.
(cont'd)
23-7
Advertisement
Table of Contents
Troubleshooting
