Honda 2002 Accord Manual page 1463

11. Disconnect the SRS main harness 18P
connector (A) f r o m the SRS unit.
12. Check resistance between the No. 10 and No. 14
terminals of the SRS main harness 18P connector.
There should be 2 . 0 - 3 . 0 Q.
S R S M A I N H A R N E S S 1 8 P C O N N E C T O R
10
14 15
16 17
W i r e s i d e o f f e m a l e
t e r m i n a l s .
Is the resistance as specified?
YES —Faulty SRS unit or poor contact at the SRS
unit connector; check the connection between the
SRS main harness 18P connector and the SRS unit.
If the connector is OK, replace the SRS unit (see
page 23-295). •
NO—Open or increased resistance in the SRS main
harness; replace the SRS main harness. •
DTC 2-3: Short to another wire or decreased
resistance in passenger's airbag inflator.
1. Erase the DTC m e m o r y (see page 23-45).
2. Turn the ignition switch O N (II), and check that the
SRS indicator light comes on for about 6 seconds
and then goes off.
Does the SRS indicator light stay on?
Y E S - G o t o step 3.
NO —Intermittent failure, system is OK at this time.
Go t o Troubleshooting Intermittent Failures (see
page 23-45).
3. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait f o r 3 minutes.
4. Disconnect the front passenger's airbag 2P
connector f r o m the SRS main harness 2P
connector (A).
0 7 T A Z - S Z 5 0 1 1 A
0 7 S A Z - T B 4 0 1 1 A
5. Connect the special tool (2 0 connector) t o the SRS
main harness 2P connector.
(cont'd)
23-83