Brother GT-3 Series Service Manual page 72

8.
Put on the Bottle on the Cover Cartridge.
9.
Confirm that the printer is either [ Standby ] or [ Ready ].
10. Select [ Maintenance ] > [ Initial Cleaning ] and ［ White ］from the menu and press OK Button.
11. When the Print Head (e.g. W1) is selected, the message [ Insert Maintenance Cartridge ] is indicated on
the Display. Remove the Filter Cartridge and insert the Maintenance Cartridge to W1 slot and press the
OK button.
Open the Cap of the Bottle and insert the Tube into the bottle. Confirm that the Tube reaches to the
bottom of the Bottle.
12. [ Close Air-in Cap ] is indicated. Confirm that the Air-in Cap is capped (closed) and press OK Button.
13. The pump starts turning and the Maintenance Solution will be installed to the Tube. It takes approx. 50
seconds to introduce the Maintenance Solution.
14. After filling the Maintenance Solution, the message [ Insert Ink Cartridge ] is indicated on the Display.
Remove the Maintenance Cartridge and insert the well-agitated White Ink Cartridge to W1 slot. Confirm
the agitation by referring to "2-6-1. Installing Ink Cartridge". Press the OK button.
15. Press the OK button to start. It takes approx. 2 minutes to install the White Ink. The pong sound rings and
the installation for W1 is finished successfully.
16. Repeat the steps 11 to 15 for the rest of the White Print Head. Execute W2, W3 and W4 for GT-381, W2
for GT-361. Confirm the amount of the Maintenance Solution in the Bottle and refill if necessary.
GT-3 Series
2. Setting up GT-3 Series
0192Y
0193Y
63