Brother GT-3 Series Service Manual page 368

Error
Message
code
4200
Message data Error
4201
4202
4300
Font data Error
4301
4302
4400
Test print data Error
4401
4402
4500 Machine Error
4501 Machine Error
4502 Machine Error
4503 Machine Error
5001
5002
Machine Error
5020
5021
5090
Machine Error
5091
5092
Machine Error
5093
5094
Machine Error
5095
5096
5101 Machine Error
5102 Machine Error
Meaning
Error in selected language data for
the Display.
Error in font data for the Display.
Error in the Print Data in the menu
for Test Print Data
Cannot start the Network Interface
Detects Illegal IP address and/or
Subnet mask.
Cannot assign Network Interface
Detects Illegal Default Gateway
Communication error inside the
firmware.
Caps were not open.
Caps were not closed.
Wipers were not move (outward).
Wipers were not move
(homeward).
Platen did not load.
Platen did not unload.
Platen did not do LF.
Illegal print area of the print data
Failure of unfolding print data
GT-3 Series
Solution
Press OK Button to recover.
Update firmware again from the beginning if you
find this error after you cancel the firmware update.
Select "Language" and reset the language.
Press OK Button to recover.
Update firmware again from the beginning if you
find this error after you cancel the firmware update.
Select "Language" and reset the language.
Press OK Button to recover.
Update firmware again from the beginning if you
find this error after you cancel the firmware update.
Press OK Button to recover. Check the network
and contact your Network Administrator.
Replace the Main PCB.
Press OK Button to recover. Assign the proper IP
address and Subnet mask with GT-3 Maintenance
Tool. Assign all "zero" for customer who does not
use LAN connection. Refer to "6-2-7. Main PCB
Assy".
Press OK Button to recover. Check the network
and contact your Network Administrator.
Replace the Main PCB.
Press OK Button to recover. Assign the proper IP
address and Subnet mask with GT-3 Maintenance
Tool.
Turn OFF and ON the printer.
Replace the Main PCB.
Confirm the Cap Motor and Cap Origin Sensor if
they work properly.
Confirm the Wiper Motor and Wiper Origin Sensor
if they work properly.
Replace the Harness: Maintenance COM.
Replace the Main PCB.
Confirm the Platen Motor, Belts and sensor.
Replace the Main PCB.
Turn OFF and ON the printer.
Replace the Main PCB.
Turn OFF and ON the printer.
The issue is in firmware; contact Brother via your
dealer.
8. Error Code List
359