Brother GT-3 Series Service Manual page 136

6.
Tighten the Tray Support Plate R (9) and the Tray Support Plate L (10) with the four Screws (11).
<Note> Pull down the back edge by hand and screw so that the front edge will lift up slightly.
(9)
(10)
7.
Connect the Connector [CN4] (12) from the Platen Motor to the Main PCB. Mount the T-shirt Tray, Platen,
Height Adjustment Lever, Clamp Lever, Cover DR, Cover DL, Cover PF, Cover PB and Cover DB.
<Note> Make sure that the Connector is firmly connected before you put covers.
Adjustment of Platen Stopping Mechanism
The space (13) should be within 32.8±0.5mm.
32.8±0.5
(11)
(12)
(13)
GT-3 Series
6. Replacing Parts
127