Brother GT-3 Series Service Manual page 129

6. Replacing Parts
Assembling
<Important!>
Mount the Upper Parts after you finish assembling the Bottom Parts; refer to the next session.
1.
Put the Front Cover UF (1) on the printer (Bottom Parts must be assembled) and fix it the two screws (11).
Mount the Link Support Plate (12) vertically by pushing up and align it with the Frame.
2.
Insert the Cover Switch (10) until it snaps and the switch is ON, and then fix it with the screw (9).
Align the Frame surface and set it vertically
3.
Put the Cover UB (8) on the printer (Bottom Part must be assembled) and fix it with the four screws (7).
<Note> Pay attention to the Tubes not to bend in operation.
4.
Fix it with the four Flat Screws (5), the four Washers (6) and cover them with the four Caps (4).
5.
Open the Front Cover UF (1) slowly with your both hands.
<Note> Without Link Springs, you feel the Front Cover UL heavier than the normal condition.
6.
Mount the Link Spring L (2) and Link Spring R (3).
7.
Close the Front Cover UF (1).
120
Insert until you
feel "click"
Lift it up
GT-3 Series
0180Y
0181Y